On Jim Tanner's advice, I obtained a rear motorcycle spring and today fitted it in the kart's sliding pillar arrangement, but it is still not quite right. My car front is down a 1/2 inch at the front. I reckon I will slide the previous spring down the inside after work tomorrow, then see where we are.
Subscribe to:
Post Comments (Atom)
Been over a year
So, it has been over a year since I did anything on this project. My dad is the only one who seems to have noticed, and it is the one proje...
-
A bit of restful R&R in the workshop today, after a late night finishing some writing for a meeting tomorrow. Trimmed and fitted my to...
-
Today I made spacers in aluminium (which encircle the stub axles, fitting between the bearings), which stop the bearings sliding towards ea...
-
Chuffed with my 25mm bearings. They will be fixed on my rear axle so that the axle can be dropped into the car's mounts and the chain dr...
No comments:
Post a Comment