I have worked out a rear brake and also a reverse system...all of which is work in progress. I have reduced my cockpit buck a bit.
Saturday, March 4, 2023
Rear bodywork - shrink and stretch
I have made my back-top panel, which will support the sides. The folded (or rather slapped-down sides have been shrunk so as to form the radius of the boat-back, using my treadle shrinker. Incidentally, I made the treadle system during lock-down.
I formed two right-angle sectioned stringers which have been edge-shrunk to the same profile as the side of the back-top panel. I know that sounds complicated, but all will become clear.
These right-angular stringers will make the body-sides hold their shape, parallel to the slapped top panel edges.
Subscribe to:
Posts (Atom)
wiring the cockpit leading edge
The shape of the front dash on the rear scuttle is replicated on the front dash of the front scuttle on the original, so I made a template u...
-
A bit of restful R&R in the workshop today, after a late night finishing some writing for a meeting tomorrow. Trimmed and fitted my to... -
Two springs make up the front suspension, an upper one and a lower one. But my range of springs is limited. I probably ought to work out the... -
The shape of the front dash on the rear scuttle is replicated on the front dash of the front scuttle on the original, so I made a template u...