Thursday, January 11, 2024

scuttle trim and fit

 

A bit of restful R&R in the workshop today,
after a late night finishing some writing for a meeting tomorrow.

Trimmed and fitted my top scuttle. It is getting there.





I wish that tank didn't look quite so much like a knob!
It is bound to get lots of comment.







The back of the scuttle will be trimmed to look just like the back of the rear one, then will be trimmed with beading for marginal safety, mainly against cut fingers (or necks!)






at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

painting

 Having been away from the project for well over a year, when I returned to it I found it had a lot of surface rust, so this week I have bee...

  • Been over a year
     So, it has been over a year since I did anything on this project. My dad is the only one who seems to have noticed, and it is the one proje...
  • front axle
     Today I made spacers in aluminium (which encircle the stub axles, fitting between the bearings), which stop the bearings sliding towards ea...
  • scuttle trim and fit
      A bit of restful R&R in the workshop today, after a late night finishing some writing for a meeting tomorrow. Trimmed and fitted my to...