Monday, November 21, 2022
Front bearings set-up
Chris sketched what he had in mind, an extra large washer to distribute the weight of the spring, with the thrust bearing and its washers ranged with a sliding fit around the pillar, though in this case, not the pillar tube but the collar at the bottom. (You will remember I used a collar attached to the top of the steering box to act as a rotating slide.)
Subscribe to:
Post Comments (Atom)
painting
Having been away from the project for well over a year, when I returned to it I found it had a lot of surface rust, so this week I have bee...
-
So, it has been over a year since I did anything on this project. My dad is the only one who seems to have noticed, and it is the one proje...
-
Today I made spacers in aluminium (which encircle the stub axles, fitting between the bearings), which stop the bearings sliding towards ea... -
A bit of restful R&R in the workshop today, after a late night finishing some writing for a meeting tomorrow. Trimmed and fitted my to...
No comments:
Post a Comment