I might even take the opportunity to make a sliding spring shroud like the original, with the lower shroud (the inner of the two) attached to the large washer and with the upper, outer shroud sliding down over the top of it.
Subscribe to:
Post Comments (Atom)
Been over a year
So, it has been over a year since I did anything on this project. My dad is the only one who seems to have noticed, and it is the one proje...
-
A bit of restful R&R in the workshop today, after a late night finishing some writing for a meeting tomorrow. Trimmed and fitted my to...
-
Today I made spacers in aluminium (which encircle the stub axles, fitting between the bearings), which stop the bearings sliding towards ea...
-
Chuffed with my 25mm bearings. They will be fixed on my rear axle so that the axle can be dropped into the car's mounts and the chain dr...
No comments:
Post a Comment